Reading in and saving Parameters
All the parameters needed by the HibridonTM code are assigned default values
appropriate to the rotationally inelastic collision of Ar with N2.
You can either redefine the full set
of input parameters by setting them one by one as described in more detail in the
parameters help file, or read in a previously defined set of parameters,
as described in more detail below.
Once the general and system parameters have been set, then can be saved
using the SAVE command
where {inputfile} designates the name of the file in which the parameters
will be stored. The variable {inputfile} can be lower or upper case, but is converted
internally so that the first character is upper case and all subsequent
characters are lower case.
Executing the command
with {inputfile} left blank, will save (overwrite) the current parameters
to the current input file. The default value of the variable {inputfile} is Inpt.
To use a preexisting set of parameters in a subsequent calculation, execute the
command
The command
causes all parameters and flags to be reread from the
current input file.
The command
The command
causes all parameters and flags to be reread from the
current input file.
The READ command is useful if you have changed any parameters or flags and wish
to restore a previous set
See also the help files SHOW and CHECK.
Demonstration example
Return to Hibridon Help